Basics Ways For Engine Methods!!

[vhadz]

thats an old picture of my piston think thats 60 or 54 i dont remember it clearly my pistons are all they sames but comes in any sizes, present now im using 62mm. same looks,

 

[ronald031803]

your right that is 62 and your block is look like UMA,,hehehe

 

[vhadz]

nope bro thats cmr 61mm, but i rebore & reslave it to 62mm,,

 

[ronald031803]

uhhhmmmm,,,

 

[aizarn20]

is that scratches on your piston sir?

 

[vhadz]

is that scratches on your piston sir?

yup, tips even though ur pistons have minimal scratches, dont dispose it, just replace new piston rings!!

 

[aizarn20]

yup, tips even though ur pistons have minimal scratches, dont dispose it, just replace new piston rings!!

thats tipid tips sir he.he

 

[vhadz]

thats tipid tips sir he.he

YEP BRO, tipid yan, what matter most is piston rings,
try to remove the piston rings and put the piston inside the bore, it still had space,,(maluwag xa,)
hope i had help my fellow newbies, theres still more to come, that i will post, tipid modes,,,

 

[odie]

sir pag nag tappet adjust ka san tinatapat dun sa 1pic. o second pic.?

 

[odie]

paps parang naka retard ka ng 10 degrees yan po ba secreto ng naka bigbore para tumagal?

 

[aizarn20]

paps parang naka retard ka ng 10 degrees yan po ba secreto ng naka bigbore para tumagal?

he..he

 

[aizarn20]

Too retarded timing will give low power, lousy emissions and excessive bore wear

 

[vhadz]

Too retarded timing will give low power, lousy emissions and excessive bore wear

thats not retard bro, in your set its retard but in mine its not, it depends on how your engine rotation or its cycle, (hindi po lahat ai exacto s timing) yan po un, try nyo po, set ur engine lets see kung sasakto xa s teth guide, na pinopoint nyo,, ( taya q bayag q jan,,) then show me some videos that it run soft.. peace bro,, our fellow forumers have ride with me, ask them if i have low powers, but i admit i have lousy engine, especially f ur using customize cams...

 

[vhadz]

paps parang naka retard ka ng 10 degrees yan po ba secreto ng naka bigbore para tumagal?

, sakin bro hindi retard yan,, baliktad q lng kabit cam q, wahaha,, hindi nmn kasi tatapat yan s teth guide khit anung gawin nyo, adjjust mo pa xa isang teeth, result nyan nakaadvance ka.. wala kana top speed pero bilis mo umarangkada

 

[vhadz]

sir pag nag tappet adjust ka san tinatapat dun sa 1pic. o second pic.?

2nd pic bro, tatlo kasi guhit nyan, lagay mo xa s gitna, at pakiramdaman mo ung pisto kung nakatop na, hugutin mo ung sparkplug tusikin mo kung nakatop n b a ung piston, for double check un bro,,

 

[aizarn20]

thats not retard bro, in your set its retard but in mine its not, it depends on how your engine rotation or its cycle, (hindi po lahat ai exacto s timing) yan po un, try nyo po, set ur engine lets see kung sasakto xa s teth guide, na pinopoint nyo,, ( taya q bayag q jan,,) then show me some videos that it run soft.. peace bro,, our fellow forumers have ride with me, ask them if i have low powers, but i admit i have lousy engine, especially f ur using customize cams...

thats for odie sir he..he peace

 

[vhadz]

wahaha, no offense nmn bro, were friends here,, ganto lng tlga aq magsalita,, mejo maangas konti, pero kakulitan lng to skin, di nmn aq mechaniko, wahaha,

 

[aizarn20]

my current cam timing is 1teeth din sir

 

[odie]

ahihihihihiihi

wahaha, no offense nmn bro, were friends here,, ganto lng tlga aq magsalita,, mejo maangas konti, pero kakulitan lng to skin, di nmn aq mechaniko, wahaha,

! hi vhadz si bro haha thanks t tried to adjust my lashes set at the middle mark, and also tried the 1mark, i like the 1st mark a lot,too lazy to open the cam cover ba yun. about the timing measured it from the timing mark and it was 20 degrees (based on the pic,actually measured it from there) so i assumed you retard it e hehe! my bad, looking forward to blowing my engine e hahaha! fish baraders!

 

[vhadz]

ahihihihihiihi

! hi vhadz si bro haha thanks t tried to adjust my lashes set at the middle mark, and also tried the 1mark, i like the 1st mark a lot,too lazy to open the cam cover ba yun. about the timing measured it from the timing mark and it was 20 degrees (based on the pic,actually measured it from there) so i assumed you retard it e hehe! my bad, looking forward to blowing my engine e hahaha! fish baraders!

wahaha, bro go for ur set, ika nga nila kanya kanyang diskarte lng yan.then feel the ride agad!! whaha ride safe,,